Chamfering Machine Operating Procedures
1. Please wear work clothes, safety shoes, and protective glasses when working. Note: Wearing gloves while operating the machine is prohibited.
2. Operators must be familiar with the general performance, structure, and drive system of the machine. Exceeding the machine's performance is strictly prohibited.
3. Before operating the machine, check that the chamfering machine's protective cover is intact and secure, and that the tool movement direction and worktable feed direction are correct.
4. Do not place metal objects on the worktable. When placing workpieces, handle them with care to avoid damaging the worktable.
5. When starting cutting, the operator secures the workpiece to the suction cup worktable with both hands and begins cutting chips. The operator controls the foot pedal depending on the length of the workpiece being cut.
6. After cutting, the workpiece must be placed as specified. Do not allow workpieces to be stacked directly on the ground.
7. If the milling cutter becomes blunt, stop the machine, change the blade, and retract the cutter before stopping. When stopping the machine, first stop the feed and then the spindle. 8. During operation, it is strictly forbidden to touch the tool tip or chips with your hands. Chips must be removed from the machine bed and milling cutter using an air gun (or brush). The machine must be stopped for chip removal.
9. During operation, it is strictly forbidden to touch the rotating spindle, workpiece, or other moving parts with your hands or any other means.
10. The operator must not leave their post while the machine tool is in operation. If any abnormality is detected, the machine must be stopped immediately.
11. After completing the work, remove chips, wipe and maintain the machine tool according to management requirements, and keep the machine clean.
12. Clean tools, measuring instruments, and the work area. Hand over the shift according to the prescribed handover system.
13. Turn off the power on the machine control panel and the main power supply in sequence.

